What is the difference between LED front and rear maintenance?

Compared with the conventional screen, the transparent LED screen can not only play a colorful picture, but also can be better combined with the application environment to display a perfect display effect. Transparent LED displays can cause some wear and tear during use, and require regular inspection and maintenance by technicians. When it comes to maintenance, the maintenance method of transparent LED screen is mainly divided into front maintenance and rear maintenance. What is the difference between these two maintenance methods?

The maintenance method is inseparable from the installation environment and installation method of the LED display. The installation method of the LED display screen is mainly divided into: hoisting installation, stacking installation and mounting installation.

Front maintenance: The front maintenance is characterized by space saving, extremely precious for indoor space, and does not leave too many places as a maintenance access. Therefore, the front maintenance can greatly reduce the overall thickness of the transparent LED screen structure, and can also save space while ensuring the effect. However, this structure has a very high requirement for the heat dissipation function of the device.

Rear-maintenance: The biggest benefit of rear-maintenance is convenience. It is suitable for roof mounting. For large transparent LED screens installed on glass curtain walls, it is easier for maintenance personnel to enter and operate from the rear.

In summary, for different application environments and actual needs, it is necessary to flexibly select the pre-maintenance or rear maintenance mode in order to better and faster repair the transparent display failure problem. Of course, technical support is also needed. Maintenance should avoid incompatibilities and mismatches during operation.

At present, Radiant transparent LED screen adopts magnetic module design, supports front and rear maintenance modes of the screen body, and only needs to replace a single module, which is simple in operation, low in maintenance cost and short in time.


Post time: May-25-2020